Jump to content
  • entries
    298
  • comments
    1,397
  • views
    144,110

Seven Hours


~Allegretto~

551 views

DeltaPlusThumb.jpg

 

 

First time I panel lined an HG, and also first time I panel lined after I finished building, instead of during; it turned out pretty well, I think; some lines, like the inside of the left knee and left shoulder (as well as the barrel of the beam rifle, or maybe that's just a shadow). I'll probably go over those with a q-tip later. Some of the lines are a bit thin, too, but there's not much I can do about that. The lines on the wings especially were kinda annoying to do because they were so shallow, so a ton of the paint spilled over and when I went over it with the q-tip it was really easy to wipe a lot of the lines I wanted to keep too.

 

The wings and shoulders seem to detach really easy, but I think that's probably because of the transformation. Shame though, because I don't think I'll use it. Tons of extra parts and taking off and reattaching sections. :/ I don't think this happens as much with other HGs; at least, I don't think my Murasame and Methuss need that many extra parts. Arios I know doesn't need any extra parts; that was one of my favorite things about it. I wish that the Delta Plus's was the same, but I guess its transformation is so complex that only the MG has enough room to do it all without the parts being microscopic.

 

Speaking of MG, I should probably finish my Zeta sometime... I still need to build the legs, back stuff, and weapons. I'm probably going to hold off on panel lining until afterward like I did here; it looks pretty nice anyway, and besides, I'm pretty much out of paint thinner.

1 Comment


Recommended Comments

Guest
Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...