Hello everyone. I'm writing to show you all how I made the BZP shirts I'll be selling soon. I've divided them into steps so no one will get confused.

Step One: Place your screen on the holder that you will be using to print the paint on the shirt. Picture

Step Two: Place your shirt on the shirt holder, be sure that the shirt is completely smooth and have no wrinkles when placed on the base. So to prevent misprinting of the t-shirts. I of course I made this mistake a few time, but it's not really noticeable. Picture

Step Three: Place the screen on top of the shirt and put paint on the screen. Picture

Step Four: Spread the paint across the screen fairly, covering up the hole image. Then use the squeegee to press hard and down on the screen about two or three times. Picture

Step Five: Lift the screen and inspect the shirt you just printed on. Picture

Step Six: Dry your shirt in the belt heater at 315 degrees about four to six times. Picture

Step Seven: Wear and enjoy! Picture